Vision Smoke Detector
ZS6101-5 is designed to sense smoke that comes into the detector chamber and send Z-Wave signal when the detector detects a certain density of smoke then the horn of smoke detector will sound. When the device is secure included into Z-Wave network, above communication will be encrypted.
The Vision Smoke Detector is a Z-Wave compatible sensor that can detect even small amounts of smoke.
When the sensor detects smoke it sends an alert signal to up to five associated Z-Wave devices, this enables the alarm to be escalated by activating other sirens or sending an email via the central Z-Wave controller. At the same time the siren will beep and flash its red LED.
The detector is easily fitted to any room’s ceiling, and as it is battery-operated requires no extra wiring. Battery replacement is simple and the detector even tells you when it need replacing by flashing its LED and sending an alert to the central controller.
This Smoke Detector uses a non-radioactive photo-electron-sensor for a reliable and safe detection of smoke. The smoke sensitivity is 0.5-4 %/ft. The smoke detector has a test button and a flashing led, so you always know that the smoke alarm is working correctly. The smoke alarm will warn you when the battery is low. When the device detects smoke, it will give a loud warning sound. It will also trigger actions in other Z-Wave devices or Z-Wave controllers to escalate the alarm. The Smoke Detector can also activate an alarm-scenario within the Z-Wave network. For example you can create an alarm-scenario to switch on all lights in the house when smoke is detected. Even at the middle of the night, you may leave the house very quickly when smoke is detected.
- Technology: Z-Wave Transmitter (868.42MHz)
- Z-Wave Groups: One group and five devices (nodes)
- Sensor: Photo-cell (smoke only)
- Push-button: Test, inclusion and exclusion
- LED: Alarm (red) and battery level/error (yellow)
- Power: CR123A 3V Lithium (included)
- Dimensions (HxWxD): 120 x 120 x 48.2mm